Quantum Code help!?!

[LipRip]

I have a quantum code baitcaster that I recently took apart to clean and oil. Upon putting it all back together i found that the drag wont tighten up like it did previously. I can get it tight if i really turn the drag adjuster hard, but it seems to tighten up my reels action too. Has anyone had a problem like this, i could really use some help!

Thanks

Shaun

[TritonTR20]

Sounds like you may have got oil on the drag disks. Remove the right side and clean the disks off and put back together.

[LipRip]

I did that last night. I pulled it back apart and made sure all the parts were in the correct spot and then wiped off the drag disk. Do you think I might need to use a chemical (like brakeKleen) to remove the oil? I'm truly out of ideas.

[TritonTR20]

Rule of thumb. oil bearings, grease gears. Drag disks should be clean. I dont think that would hurt them. If they had grease or oil on them it would deffinatly cause your problem.

[LipRip]

Thanks for your help triton!