rotisserie

[troossien1]

at a loss.... I dont want to break the bank and I dont know what to do for a rotisserie for my baits. I need the epoxy to dry properly. or does anyone have any other suggestions for getting a really good hard clear coat on them?

[thedude]

http://www.ebay.com/itm/like/310707272047?lpid=82

microwave gear motor. mount it to a board and plug it straight AC outlet. epoxy a half inch dowel rod to the shaft and screw aligator clip ends onto the dowel. clip baits by the eyelets.

[Redbone]

http://www.amazon.com/Grillmark-Replacement-Rotisserie-Motor-Lbs/dp/B003CHAKF8/ref=sr_1_1?ie=UTF8&qid=1390220665&sr=8-1&keywords=rotisserie+motor

I purchased one like this. You will need to make a mount and rig up a way to hold the baits like the dude said. But definitely wont break the bank this way.

[21XDC]

http://www.amazon.com/Grillmark-Replacement-Rotisserie-Motor-Lbs/dp/B003CHAKF8/ref=sr_1_1?ie=UTF8&qid=1390220665&sr=8-1&keywords=rotisserie+motor

I purchased one like this. You will need to make a mount and rig up a way to hold the baits like the dude said. But definitely wont break the bank this way.

This is what I use too, But I never saw one that cheap....   

[Redbone]

I thought the same thing this morning when I looked it up. I paid $15 bucks for the same motor a couple of months ago.

[detroit1]

I use a Char-Broil rotisserie , with forceps taped to the 8 prongs. I think it was about $25 (5 yrs. ago)...

[troossien1]

Thanks guys! We will see how it goes!