Text only | Text with Images

Great Lakes Bass Fishing Forum

Bass Fishing => Bass Fishing Tips, Techniques & General Discussion => Topic started by: Frank on April 14, 2014, 12:59:27 PM

Title: SI transducer, broken plate
Post by: Frank on April 14, 2014, 12:59:27 PM
The bottom plastic plate broke off my transducer and now lives in the bottom of the lake.  will it be fine, or is there a way to fix it?

Thank You
Frank Benning
Title: Re: SI transducer, broken plate
Post by: Firefighter Jeff on April 14, 2014, 08:24:25 PM
  Use a Transducer Shield and Saver for the new transducer !!!!      :-\'
Title: Re: SI transducer, broken plate
Post by: dartag on April 14, 2014, 08:29:15 PM
was it the hard plastic where it is molded together.  You may be able to use epoxy and make a new plate.  Try a few coats and see if it works. 

good luck
Title: Re: SI transducer, broken plate
Post by: Frank on April 17, 2014, 11:52:09 AM
it has a transduce save on it.  it caught on the trolling motor mount when pulling it out of the water.  i shall try epoxy and see how that is. 
Title: Re: SI transducer, broken plate
Post by: Firefighter Jeff on April 23, 2014, 09:00:01 PM
Quote from: Frank on April 17, 2014, 11:52:09 AM
it has a transduce save on it.  it caught on the trolling motor mount when pulling it out of the water.  i shall try epoxy and see how that is. 

   Gotchya, sorry.     :-\'
Title: Re: SI transducer, broken plate
Post by: Firefighter Jeff on April 23, 2014, 09:00:54 PM
  So, did the epoxy work ??
Title: Re: SI transducer, broken plate
Post by: Frank on April 24, 2014, 03:03:33 PM
i havent tried yet, but i shall soon
Title: Re: SI transducer, broken plate
Post by: Rangerman on April 27, 2014, 07:54:37 AM
The transduce shield is the way to go. Works great and does not catch on TM mound. My old one did.
Text only | Text with Images