Great Lakes Bass Fishing Forum
About Fishing Products including Make Your Own => Boats, Outboard Motors, Prop & Trailer Talk => Topic started by: TheFishinPollock on May 14, 2012, 10:16:54 PM
Well. It wasn't anything that anyone did that broke it. I shattered the pin that hold the piston rings from spinning around on the piston. The block is now at the machine shop to get another cylinder bored out from soem scarring.
Could have been worse !!!! Hope your back on the water soon.
Glad to hear it wasn't worse although breaking that pin is bad enough. And then to have to have a cylinder bored out.........again. Don't worry, it's only money. Hope you're back on the water soon.
BD. ;D